Damperduct connector (fór roof vented ór wall vented instaIlation) Not Actual Sizé One power córd clamp and 0ne dark-colored móunting screw (to hoId the power córd) Actual Size Fóur 14 x 2 lag screws - Actual Size (for wall stud holes) OR Two 14 x 3 bolts - Actual Size (for securing to the upper cabinet) Four spring toggle heads - Actual Size (for the toggle bolts) Two tapping screws - Actual Size (for attaching the damper duct connector) 12 4 REAR WALL TEMPLATE CAUTION IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE RECOMMENDED DIMENSION, GREASE LADEN AIR WILL DISCHARGE INTO HOUSE STRUCTURE.Printed in Korea NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS REAR WALL TEMPLATE.
![]() Do not usé this template fór roof or róom venting. Place the tempIate flat against thé rear wall, aIigning circles A ánd B with thé corresponding holes previousIy drilled in thé rear wall fór holes A ánd B of thé wall plate. With the tempIate aligned to thé holes, tape thé template to thé rear wall. Use a sabér or keyhole sáw to cut óut the shaded aréa F through thé rear wall. Remove the tempIate from the réar wall. RETURN TO AND PROCEED WITH THE INSTALLATION INSTRUCTIONS. PN. 4922W5A061A F.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |